riginal A Theme from Aston, PA area. Clean PA title Vin
A9M097X293183.
Door tag
Body -059057
model 6909-7
Trim 941-D
Paint - Special
E097673
Original SC/Rambler wheels
Door tag is photographed detached. It came of the original door which
you will se in the photo's as an "extra door" I got when I purchased
it.
VIN number behind steering box matches car.
Engine (1968 390) has been re-done tanked and balanced. New bearings,
cut crank .40 over new theraputic heads with a Doug Herbert mild cam.
Heads re done with new valve guides, valves springs etc:. Short block
assembled. I have everthing else to complete, including new water pump,
assembly bolts etc: Original intake and carb - and Edelbrock / AMC cross
ram -- old and NOS linkage included. (no carbs). -- I have almost 9k into
the engine, bumpers and x/ram alone.
T-10 tranny checked at the shop and I was given the OK with it. Has original
hurst linkage and I also have another re-conditioned Hurst linkage set
up for it. Scatter shield and bell housing. New clutch and freshly cut
flywheel. Original shifter and handle.
Set of re-done front and rear bumpers from bumper boyz.
Seats re-foamed and re-done in a black basketweave. With original RWB
head rests (I have a set of black head rest included. Seats were re-done
before I finally located the orignal material out in Oregon. - go Figure.
Original exhaust manifolds and piping which was fairly new when I got
it and extra parts (check out the photos). I know the shocks are shot
and they will need replacing. Body wise it's not bad. Only sheetmetal
problem is where the seats bolted to the floor, the holes are bigger and
some what gone and should be re-done. Quarters appear wavy but solid and
magnet still grips firm . All glass in place. No headliner. Extra parts
not photographed as well.
If your interested I want 20K for the car - good deal actually. If I ebay
it, I'll put it on with a 20k reserve and 22k buy it now. Let me know.
George 914-438-7185 or email. Donutblue@aol.com
Original A Theme from Aston, PA area. Clean PA title Vin A9M097X293183.
Trim tag
Body -059057
model 6909-7
Trim 941-D
Paint - Special
E097673
Original SC/Rambler wheels
Door tag is photographed detached. It came of the original door which
you will se in the photo's as an "extra door" I got when I purchased
it.
VIN number behind steering box matches car.
Engine (1968 390) has been re-done tanked and balanced. New bearings,
cut crank .40 over new theraputic heads with a Doug Herbert mild cam.
Heads re done with new valve guides, valves springs etc:. Short block
assembled. I have everthing else to complete, including new water pump,
assembly bolts etc: Original intake and carb - and Edelbrock / AMC cross
ram -- old and NOS linkage included. (no carbs). -- I have almost 9k into
the engine, bumpers and x/ram alone.
T-10 tranny checked at the shop and I was given the OK with it. Has original
hurst linkage and I also have another re-conditioned Hurst linkage set
up for it. Scatter shield and bell housing. New clutch and freshly cut
flywheel. Original shifter and handle.
Set of re-done front and rear bumpers from bumper boyz.
Seats re-foamed and re-done in a black basketweave. With original RWB
head rests (I have a set of black head rest included. Seats were re-done
before I finally located the orignal material out in Oregon. - go Figure.
Original exhaust manifolds and piping which was fairly new when I got
it and extra parts (check out the photos). I know the shocks are shot
and they will need replacing. Body wise it's not bad. Only sheetmetal
problem is where the seats bolted to the floor, the holes are bigger and
some what gone and should be re-done. Quarters appear wavy but solid and
magnet still grips firm - Tom looked at this car when I came up for the
Machine. All glass in place. No headliner.
George 914-438-7185
|